Next in the installs is the CPS1 Multi with a big chunk of addons by Mitsurugi-W The install of the multi itself was relatively simple, remove the old B and C boards, a couple solder points Filter board installation and bob’s your uncle! A working CPS1 multi The installation of Continue Reading
mR_CaESaR
CPS3 Multi and Ultra Simms
I’ve done a couple of Darksoft Multis over the last couple of weeks. These are for DRAGONKZ This one is the CPS3 Ultra SIMMS The CPS3 Ultra Simms allow you to load up all CPS3 games on flash and switch between all of them making it instant vs waiting 40 Continue Reading
CPS3 PCB Supports
Some of the biggest pain points for CPS3 owners is the PCB flexing where you install the cart. Over time, the customs around the pcb eventually require reflowing causing a number of issues on the board. Thanks to clintkolodziej on Arcade Projects for designing these CPS3 pcb supports to alleviate Continue Reading
Egret 2 – Cleaning, wiring, putting it all back together
The cab has been cleaned as best as I can and the last thing to do is give it a cut and polish, but she’s definitely looking MUCH better than when I first got it. With the chassis arriving back from Joey the other day, it was time to put Continue Reading
Egret 2 – speakers
Let’s talk speakers After using the Logitech Z407’s on my outrun2 cab, I thought this would be a perfect set of speakers to use on this machine to give it that 2.1 upgrade. Trawled through marketplace and found it half price compared to when I purchased mine at Bing Lee Continue Reading
Egret 2 – control panel and general update
It’s been a while since the last update – I always dread updates that’s why they’re so far in between haha I was bumbed for a little while as the temporary ms9 I had stopped working luckily, the proper MS9 from the cab was being serviced by JOMAC and it wasn’t Continue Reading
Rhythm Tengoku – Control Panel part 2
As previously mentioned, I had planned to wire harness with a JAMMA edge like this: @LemonyVengeance gave me the idea of bypassing the JAMMA edge and just wire it directly to the Blast City I/O. Due to the sheer amount of wire I needed, I figured it would be cheaper to Continue Reading
Egret 2 – Rotation Mech
Rotation Mech Time to rotate! After all, this is what the Egret is renowned for right? What a VERY nerve wracking experience that was to turn. Give me a frame, lift and turn any day of the week hahaha. I needed to make sure most of the cable ties were Continue Reading
Egret 2 – wiring
Wiring Saturday was all about wiring! Got to love Operators and their hack/splice and do whatever they need to get something to work. There are better ways to do things, but I understand from an Op’s perspective. This is what I started working with. After unraveling it all, I confirmed Continue Reading
Egret 2 – worklog update
Been working on this here and there over the past few days, but managed to get some solid time on Saturday. Monitor I can understand why I’ve heard of people “necking” their tubes on this cab. If you’re not careful and if you haven’t checked the wires if there’s enough Continue Reading