Point Blank is now officially in its rightful spot now! This cab is done and fully playable. Artwork for the bezel and a Japanese marquee is all that I am after
Worklog
There is light at the end of a very long tunnel!
The light at the end of the tunnel is so close with this cab! With the video issues now solved, it’s now time to get the cab back to working order – first order of business was doing a general clean and fixing up a few nuances on the cab. Continue Reading
Sync Issue Discussion
Let’s now talk Point Blank 1 and this damn stupid sync issue! This is how I know I have sync issues when I play Point Blank Notice how the squares aren’t square? When I use the EMI filter with the resistor pcb ‘out’ going to the game pcb and ‘in’ Continue Reading
Point Blank Monitor Calibration
Spent some time the other night calibrating the monitor. I don’t know if I’m going to bother with corner convergence, I’ve been down that route before with the Blast City and it’s one quite annoying job You can clearly see corner convergence being a problem After enough time with the Continue Reading
Point Blank Breakthrough!
After finally admitting defeat the other day, I started thinking about how to install the game using JAMMA. When I purchased a Point Blank PCB, I was also given a Point Blank wiring harness with the JAMMA edge connector so I thought I’d use that and retro fit it into Continue Reading
Point Blank Troubleshooting
Here’s what I’ve done so far My next test is to bother DRAGONKZ and connect both my Point Blank 1 and Point Blank 2’s with their respective EMI Filter Boards and see if it also exhibits the same issue to completely rule out the EMI Filter boards being the issue. Continue Reading
Point Blank Set Back
This has slowed down a little as I haven’t really had the chance to do much to it. Work and life has been a little crazy since getting this cab. I’ve managed to do a few of the cosmetic items. Collected my point blank header from and it’s night and Continue Reading
Tube Swap
I had a couple of hours Saturday morning to get the tube swap going. First order of business is to put the cabs side by side so I can just slide the frame from one cab to another Slide the tube from the Point Blank cab, placed it on the Continue Reading
Dedicated Point Blank Machine
A dedicated Point Blank machine has been in the “want to buy” for many years. I can now officially say, one of my last grails has been purchased! Time Crisis 1 can now be sold off and this will replace it. Got delivery of this cab last Monday and when Continue Reading
Atomiswave Stereo Amp Upgrade
The last major part is the Stereo Amp. Enter Sega’s 601-10369 Stereo Amp! It’s in a nice cage and has the step down transformer built into it. Prefer to use arcade amps instead of the 12v leppy ones from ebay on these candies if I can. The taito one would Continue Reading