Tekken 8 has been out for a while and the Namco Noir has always been known as the “Tekken Cab” since T6 so it was only natural that I made the Noirs T8 compatible. Since the PS5 is my primary way to play SF6, I wanted another dedicated setup so Continue Reading
Arcade
CPS2 Conversion – SF2 New Challengers to Progear!
A mate asked if I could do CPS2 conversions and I’ve previously done them so I said I was happy to do it for him. He wanted to convert his SF2 New Challengers board to something that he would play more – enter Progear. It also helps to convert as Continue Reading
CPS2 Bubble Bath
I was trying to clear out some surplus arcade stuff and this CPS2 was the first one on the chopping block. She’s not in the greatest condition externally, but I knew this was a revision 7 board would make a perfect darksoft multi donor. Since I don’t like to just Continue Reading
She’s home!!
Point Blank is now officially in its rightful spot now! This cab is done and fully playable. Artwork for the bezel and a Japanese marquee is all that I am after
There is light at the end of a very long tunnel!
The light at the end of the tunnel is so close with this cab! With the video issues now solved, it’s now time to get the cab back to working order – first order of business was doing a general clean and fixing up a few nuances on the cab. Continue Reading
Sync Issue Discussion
Let’s now talk Point Blank 1 and this damn stupid sync issue! This is how I know I have sync issues when I play Point Blank Notice how the squares aren’t square? When I use the EMI filter with the resistor pcb ‘out’ going to the game pcb and ‘in’ Continue Reading
Point Blank Monitor Calibration
Spent some time the other night calibrating the monitor. I don’t know if I’m going to bother with corner convergence, I’ve been down that route before with the Blast City and it’s one quite annoying job You can clearly see corner convergence being a problem After enough time with the Continue Reading
Point Blank Breakthrough!
After finally admitting defeat the other day, I started thinking about how to install the game using JAMMA. When I purchased a Point Blank PCB, I was also given a Point Blank wiring harness with the JAMMA edge connector so I thought I’d use that and retro fit it into Continue Reading
Point Blank Troubleshooting
Here’s what I’ve done so far My next test is to bother DRAGONKZ and connect both my Point Blank 1 and Point Blank 2’s with their respective EMI Filter Boards and see if it also exhibits the same issue to completely rule out the EMI Filter boards being the issue. Continue Reading
Point Blank Set Back
This has slowed down a little as I haven’t really had the chance to do much to it. Work and life has been a little crazy since getting this cab. I’ve managed to do a few of the cosmetic items. Collected my point blank header from and it’s night and Continue Reading